Steam pipe replacement
SKU: D902Defective steam tap, but you never use it? With this coupling you can omit the steam tap, especially for the 800 series. When discontinuing the 3000 series, you must also order a new pressure hose, as the already mounted hose is too short.
The coupling is self-sealable. If the nut on your current hose has a different thread, proceed as follows: You cut off the crown, the nut of the new coupling goes over the pressure hose, then you press the hose well onto the coupling and then tighten the nut. A little grease between the nut and the hose is recommended.
Tip: watch our Youtube videos at the bottom of the page under tips and tricks QuickMill! You must remove the entire steam tap from the machine.
